Replace EVO Nano Drone Propellers
The EVO Nano's propellers are attached with screws. Before replacing the propellers, prepare the replacement blades, screws, and screwdriver.
1. Remove the propellers
Hold the motor and old propeller and rotate the screwdriver counterclockwise. Remove the screws and propellers and repeat with the other propeller sets.
2. Attach the propellers
You must first match the correct blades to the correct arms, if a propeller is marked with a dot, mount this on the motor whose arm has the corresponding dot. If there is no dot on the propellers, attach to a motor that does not have a dot.
Put the screw through the propeller's hole, then set it on the motor. Rotate the screwdriver clockwise to tighten. Repeat this with the correct propellers in the correct motors.
when finished, double-check to make sure all the propellers are properly attached and tightened securely.
